Vote for The Forward Look Network on the Mopar Top 100 Sites 

Re: Very hard brake pedal on '55 NYer problem

From: Dan
Email: Dan(at) (replace at with @ to email)
Remote Name:
Date: October 21, 2003


Adam You may have crud in your lines. Flushing may help. I took apart a 58's brake system. I found a ton of crud in each cylinder. Also there was crud in the brake light switch. The half of the cylinders were rusted. They weren't helping the stoping factor. I should point out that this car was last regularly driven in 1975. Make sure that you get a full streem at each bleader on each slave cylinder. Dan


Last changed: July 19, 2018