Vote for The Forward Look Network on the Mopar Top 100 Sites 


Re: connecting rod nuts stripped on studs...how to get them off?

From: Mopar Randy
Email: Randyblizzard@aol.com
Remote Name: 205.188.209.43
Date: October 30, 2003

Comments

You might try a good nut splitter on them. If that doesn't work, perhaps cutting them ALMOST all the way through with something like a Dremel cutting disk and then splitting them off with a cold chisel, much the same was as removing the bearing collars from the flanged axle Chryslers, might work. I can't personally attest to either of these methods for your particular problem as I have never had that happen. Just a thought by way of assistance. Good luck, Mopar Randy

 


Last changed: May 04, 2010