|
|
Veteran
Posts: 159
Location: Rittman, Ohio (Near Akron) | Not cheap, but the best chrome plating work I've seen. The bumper I had them rechrome was done in their factory finish, but it looked better than most people's show finish when I got it back.
http://www.customchromeplating.com/
Edited by munja 2006-05-30 6:22 PM
|
|
|
|
Veteran
Posts: 259
Location: Detroit MI area | I'm starting to research chrome places for my car. Its been years since I had any of this work done. Don't want to be nosey enough to ask the exact price, but can you give us a price range for the part?
Thanks,
Jim |
|
|
|
Account Suspended
Posts: 2827
Location: At "The Rock" in upper East Tennessee | I hate to be nosey as well but I would like a price range as well |
|
|
|
Wise Old Village Idiot
Posts: 3591
Location: Dellslow, West ("By God") Virginia ! | I had some plating done there, back in the late '70's Perfect! Prices were a little cheaper than Paul's, up above Pittsburgh.
Problem was, Grafton was a speed trap town. The guy at Custom Plating, even told me over the phone. Drive the speed limit, or BELOW. For they give out tickets for 1 mile over the limit! |
|
|
|
Veteran
Posts: 159
Location: Rittman, Ohio (Near Akron) | It cost me about $800 bucks to get my 59 bumper chromed. It was very warped and rusted.
Edited by munja 2006-06-03 4:29 PM
|
|
|
|
Expert ,, George Passed away July 28th 2021, He will be Missed
Posts: 1295
Location: Twin Falls, Idaho | I have to agree on the quality for the most part.... especially on pot metal parts. The only problem I have with them is the time it takes to get the pot metal done. My experience has been a minumum of about 16 weeks and as long as 24 weeks. I have recently been using Sihiling Plating in Santa Ana CA. Price is about the same as Custom Chrome Plating but the turn around on pot metal has been 3 to 4 weeks..... excellent work so far. I also had Custom Chrome Plating restore 4 1958 FARGO hubcaps and the job they did was beyond my wildest expectations...... absolutely superb!! |
|
|
|
Expert
Posts: 1302
Location: Skaneateles,NY(summer)/Port St.Lucie,FL(winter) | "Sandy's Bumper Mart" Syracuse, NY. '55 DeSoto front bumper, natsy rust, bent. Rechromed the bumper/both Dagmars show quality $450... |
|
|
|
Veteran
Posts: 180
Location: san ramon, CA | Here is a company on the west coast the looks like they do a good job... I may look them up when I'm looking to chrome (haven't dealt with them yet)... They have some estimates online... Don't know what the shipping cost would be...
http://www.thebumpershop.com/TheBumperShop/PartsSelect4.asp?SearchM...
|
|
|
|
Veteran
Posts: 157
Location: Ocala, FL |
The website has no Plymouth parts listed.
Do they carry Plymouth stuff and just forgot to list?
Steven |
|
|