Sticky FL-service
wizard
Posted 2014-08-03 4:28 AM (#451437)
Subject: FL-service



Board Moderator & Exner Expert 10K+

Posts: 13078
5000500020001000252525
Location: Southern Sweden - Sturkö island
With start from the 1st of September I'll be offering service on the FL-cars and options.
I will perform the service as in the old days, with the proper methods and a reasonable charge.
Naturally, I aim this service to members close to my location, but options could be shipped for renovation.

For requests, see my profile for contact info, or send me a PM.

Med början från första September kommer jag att erbjuda service på FL-bilar och dess tillbehör.
Servicen utförs som förr i tiden med rätt metoder till en rimlig kostnad.
Jag vänder mig i första hand till bilägare i min närhet, men tillbehör kan skickas till mig för reparation.

Vid förfrågningar, se kontaktuppgifter under min profil, eller skicka mig ett PM.


Sven "Wizard" Andersson
Top of the page Bottom of the page
wizard
Posted 2014-10-17 9:41 AM (#459515 - in reply to #451437)
Subject: Re: FL-service



Board Moderator & Exner Expert 10K+

Posts: 13078
5000500020001000252525
Location: Southern Sweden - Sturkö island
The work goes along ´nice now; I installed headlight relays in one car, made a TorqueFlite service on a '59 DeSoto Shopper - right now I'm busy with "our" Dieters '56 New Yorker that will be here over the Winter. Still, it's possibly to fit in some more work...........
Top of the page Bottom of the page
di_ch_NY56
Posted 2014-10-17 4:49 PM (#459551 - in reply to #459515)
Subject: Re: FL-service



Expert

Posts: 1532
100050025
Location: ZH, Switzerland

wizard - 2014-10-16 3:41 PM The work goes along ´nice now; I installed headlight relays in one car, made a TorqueFlite service on a '59 DeSoto Shopper - right now I'm busy with "our" Dieters '56 New Yorker that will be here over the Winter. Still, it's possibly to fit in some more work...........

Thank you very much for your work on my Chrysler. I appreciate your work so much. Thank you very much.

 

Happy Motoring!

 

Dieter

 

BTW: I recommend Wizard from my heart for all works at the Forwardlook area cars.





(IMG_1504.jpg)



(IMG_1515.jpg)



Attachments
----------------
Attachments IMG_1504.jpg (118KB - 871 downloads)
Attachments IMG_1515.jpg (130KB - 851 downloads)
Top of the page Bottom of the page
Skilling500
Posted 2015-02-04 8:24 AM (#469346 - in reply to #451437)
Subject: Re: FL-service


New User

Posts: 3

Location: Sverige
Säljer du delar också ? såg att du bodde bara några mil från mig, Mvh Magnus.
Top of the page Bottom of the page
wizard
Posted 2015-02-04 9:02 AM (#469347 - in reply to #451437)
Subject: Re: FL-service



Board Moderator & Exner Expert 10K+

Posts: 13078
5000500020001000252525
Location: Southern Sweden - Sturkö island
Hej Magnus, kul med en koncernbroder så nära. Jag skickar dig ett PM med min privata mailadress så jag får veta vad du söker efter.

Sven
Top of the page Bottom of the page
Skilling500
Posted 2015-02-04 11:19 AM (#469352 - in reply to #451437)
Subject: Re: FL-service


New User

Posts: 3

Location: Sverige
Kanon :-)
Top of the page Bottom of the page
1959Dodge
Posted 2015-02-04 8:06 PM (#469383 - in reply to #451437)
Subject: Re: FL-service



Expert

Posts: 2244
200010010025
Location: Yorba Linda, Ca
Well come to California again Wizard, perhaps one of my cars will need service
.
Well, come to think of it, the 59 Dodge leaks tranny fluid and the 58 Chrysler
leaks brake fluid.

You best hurry back here!!!!!

Gary
Top of the page Bottom of the page
wizard
Posted 2017-03-24 2:03 PM (#536602 - in reply to #451437)
Subject: Re: FL-service



Board Moderator & Exner Expert 10K+

Posts: 13078
5000500020001000252525
Location: Southern Sweden - Sturkö island
This Winter I serviced only one Forward Look car - a 1961 New Yorker 4DHT - leaking cast iron hog and propeller shaft booth replacement.
Several AstraDome service and gauge repairs as well as cancel switch renovations.

I worked a lot on some GM products though, everything from steering, stereo installation, carpet, upholstery, rear axle and electrical trouble shooting.

Should you live close by, don't hesitate to contact me for advices and help.
Top of the page Bottom of the page
Adventurer 60
Posted 2017-04-18 1:53 AM (#538291 - in reply to #451437)
Subject: Re: FL-service



Elite Veteran

Posts: 827
50010010010025
Location: tailFinland
Hi Wizard do yo fix turn signal switches (Chry 60-62)
I got 2 broken ones, one works (blinks) but magnet does not hold blinker on, other has one of the two blastic parts broken inside, but magenet works.
Top of the page Bottom of the page
wizard
Posted 2017-04-18 4:39 PM (#538320 - in reply to #451437)
Subject: Re: FL-service



Board Moderator & Exner Expert 10K+

Posts: 13078
5000500020001000252525
Location: Southern Sweden - Sturkö island
Yes, I have parts so I can repair the cancel switches. Send me an email ....
Top of the page Bottom of the page
wizard
Posted 2018-02-07 7:01 AM (#557636 - in reply to #451437)
Subject: Re: FL-service



Board Moderator & Exner Expert 10K+

Posts: 13078
5000500020001000252525
Location: Southern Sweden - Sturkö island
Electroluminiscence Service

Gauge Service

News; Clock Service, specialty '60-'62

News; Vacuum Switch Unit Service



(IMG_2439-rez.jpg)



(IMG_2426-rez.jpg)



(IMG_0908-rez.jpg)



Attachments
----------------
Attachments IMG_2439-rez.jpg (218KB - 639 downloads)
Attachments IMG_2426-rez.jpg (174KB - 626 downloads)
Attachments IMG_0908-rez.jpg (113KB - 663 downloads)
Top of the page Bottom of the page