Anybody have a couple of needles
koob
Posted 2016-01-30 2:55 PM (#502753)
Subject: Anybody have a couple of needles



Veteran

Posts: 120
100
Location: Bryan, TX

for a ball and trunion joint? I seemed to have lost one or two. Please reply or contact me if you can help.  Thanks.

 

Tim Kubiak

979-229-3740

Top of the page Bottom of the page
udoittwo
Posted 2016-01-31 9:46 AM (#502821 - in reply to #502753)
Subject: RE: Anybody have a couple of needles


Expert

Posts: 1348
100010010010025
Location: Valley Forge, Pa.		Hey Tim,

Been there but I've always been told that you should never put different bearing sets together especially if they are used. Even new, manufactorers may be very slightly different.

I built a new driveshaft and did away with the trunion joint. I have a rebuilt kit that I am not going to use and am just now listing a NOS or maybe its NORS[?] rebuild kit for a 1960 Plymouth under "parts for sale" on this forum. I see them listed from $70 to 120 give or take and I am asking a lot less. You haven't said a year but I am guessing they all are the same?

Karl.
Top of the page Bottom of the page
koob
Posted 2016-01-31 11:41 AM (#502841 - in reply to #502753)
Subject: Re: Anybody have a couple of needles



Veteran

Posts: 120
100
Location: Bryan, TX		PM sent.
Top of the page Bottom of the page