|
|
Regular
Posts: 59
| Parting out what remains from a ‘59 Dodge sedan. Rear 1/4s, doors, hood, some exterior trim, guage cluster.
Let me know what you’re after, I may be able to help. |
|
| |
|
Expert
Posts: 4440
 
| where are you at? |
|
| |
|
Regular
Posts: 59
| Sherwood Park, Ab Canada |
|
| |
|
Regular
Posts: 70
Location: North East Pennsylvania | What engine is in this car? I'm in search of engine mounts for '58 or '59 Plymouth/Dodge Big Block. |
|
| |
|
Extreme Veteran
Posts: 369
Location: buchanan,Ga. | looking for a set of trunk hinges |
|
| |
|
Regular
Posts: 59
| Should have those, will confirm and get back to you. |
|
| |
|
Regular
Posts: 59
| PM sent |
|
| |
|
Member
Posts: 10
| Does that have the 326 motor? |
|
| |
|
Elite Veteran
Posts: 849
Location: Milwaukee Wisconsin | Any Pics of car ? What model , 2dr 4dr ? |
|
| |
|
Regular
Posts: 59
| Was a 4dr Custom Royal. Exterior trim, some interior pieces left |
|
| |
|
Expert
Posts: 4440
| hood ornament? |
|
| |
|
Elite Veteran
Posts: 849
Location: Milwaukee Wisconsin | <p>need this molding with the angled 45* molding cap.</p><p>and this inner back glass garnish molding it's curved , painted.?</p>
Edited by dodge59 2020-10-30 11:02 AM
 (s-l1600 (2).jpg)
 (rear glass molding 50%.JPG)
Attachments
----------------
 s-l1600 (2).jpg (86KB - 76 downloads)
rear glass molding 50%.JPG (74KB - 73 downloads)
|
|
| |
|
Regular
Posts: 59
| No sorry, no transition piece. Should have the interior window trim. Will have a look for it and get back to you. |
|
| |
|
Regular
Posts: 59
| Sorry, no hood ornament |
|
| |
|
Member
Posts: 10
| 326 motor??? |
|
| |
|
Elite Veteran
Posts: 849
Location: Milwaukee Wisconsin | I think there is a horizontal garnish trim piece just under the verticle one too. not sure . |
|
| |
|
Regular
Posts: 59
| Was 326, but was scraped with the shell. I kept the heads and manifolds |
|
| |
|
Expert
Posts: 3572
Location: Connecticut | Ted - Please let me know if these are still available:
Rear of front fender moulding. Runs from front wheel well to rear edge of fender. It's actually two pieces. Both sides. Steering wheel ? Is it the plastic, two-tone variety ? Can you post a photo or message me a photo ? Can you check the trunk floor to see if the original trunk mat is inside. Should be rubber with small rectanges. D-O-D-G-E lettering on trunk. Only if shiny and pit-free. Thanks, Ron |
|
| |
|
Elite Veteran
Posts: 849
Location: Milwaukee Wisconsin | so the Body / Shell is gone ? scraped ? |
|
| |
|
Regular
Posts: 59
| Yes. All usable parts were removed and the shell scraped. |
|
| |
|
Regular
Posts: 59
| Ron, I’ll send a pm |
|
| |
|
Veteran
Posts: 287
| Got the turn signal arm for it maybe? What about the fender mirrors? |
|
| |