|
|
Veteran
Posts: 292
Location: Twin Cities MN | Noticed at least some of these studs go straight thru head into rocker area. Have all new ones from HHH to install and wondered what is best sealant/thread locker to use on the threads going into head? Have a variety of sealers and locking compounds on hand, but not sure which to use. I am using the stock exhaust manifolds.
Thanks, Mike |
|
|
|
Expert
Posts: 3027
Location: N.W. Fla. | The others go into water, @ least on the Chr. Tube of copper coat, best I recall. |
|
|
|
Expert 5K+
Posts: 9604
Location: So. Cal | I used the gray silicone gasket maker. It has worked very well with no leaks. But I didn't seal the old studs thinking that they were already good. Wrong. I now have a leak on one of them that I never touched. I'm sure it will seal itself again eventually since it is very minor. |
|
|