392 industrial Hemi parts
Apollo 61
Posted 2020-04-27 3:35 PM (#597418)
Subject: 392 industrial Hemi parts



Extreme Veteran

Posts: 528
50025
Doing a garage clean out for customer today and got these Hemi industrial parts.
Not sure what exactly they fit? Customer said marine 392?
One has casting date of 57 and other 58.
Can anybody tell me what these are for?
Will sell cheap but shipping will be expensive as there heavyyy



Attachments
----------------
Attachments image.jpeg (191KB - 124 downloads)
Top of the page Bottom of the page
Powerflite
Posted 2020-04-30 3:09 AM (#597537 - in reply to #597418)
Subject: Re: 392 industrial Hemi parts



Expert 5K+

Posts: 7292
50002000100100252525
Location: So. California
I believe the one with the large round circle and the pulley next to it is marine, and the other one is industrial, but it could be marine as well for the other end of the motor, I'm not sure. I don't know of any market for these parts. You may have to go to a boat or tractor site to find any interest in them. Count the number of teeth on the flywheel to determine the application for it. It could be used for any original manual trans setup.

Edited by Powerflite 2020-04-30 3:13 AM
Top of the page Bottom of the page