|
|
Veteran
Posts: 209
| Hello, I have a complete 1963 300J 413 Short Ram engine and need a few small parts. I need the steel heat riser tubes shown in this picture (the steel tubes that connect the intakes to the exhaust manifolds) my originals were rusted. The tubes shown are reproductions, can anyone point me to the vendor who makes and sells them?
Edited by Scott Smith Harms 2022-04-02 5:45 PM
 (Short Ram tubes-Small.jpg)
Attachments
----------------
 Short Ram tubes-Small.jpg (89KB - 94 downloads)
|
|
| |
|
Expert
Posts: 1223
Location: Ramona, CA | Check with Waldron's Exhaust. They make them for the 300F and 300G although they are going from the intakes to the steel exhaust headers instead of those. |
|
| |
|
Veteran
Posts: 256
Location: Chicago | Those could be from a 300 Club International guy who had a small run of these made several years ago as a private non-club side project. Pretty sure they are long gone. Waldrons sounds like a good bet |
|
| |
|
Expert
Posts: 2289
Location: Eastern Iowa | I made a bunch of those about 45 years ago and could hardly give them away.
BTW, they are/were a gigantic PITA to produce, especially the flanges.
Edited by finsruskw 2022-04-05 8:22 AM
|
|
| |
|
Veteran
Posts: 209
| Thanks for the replies guys. I have one good original but still need one. I'd buy a pair, whatever it takes. If I need to get some made custom I will if anyone wants to offer tips they will be gratefully received.
 (8BC.jpg)
Attachments
----------------
8BC.jpg (30KB - 93 downloads)
|
|
| |