|
|
Regular
Posts: 51
| parting out 56 dodge royal 4 door hardtop good rust free doors fenders and rust free quarters good driver quality bumpers hood and trunk lid lots of other good parts call george 406-5432591 |
|
|
|
Elite Veteran
Posts: 792
Location: Buena Park, CA | Do you have a cowl vent slider bezel that mounts under the dash. Look like this:
(2014-07-05 10.08.48.FL.jpg)
Attachments ---------------- 2014-07-05 10.08.48.FL.jpg (71KB - 249 downloads)
|
|
|
|
Veteran
Posts: 292
Location: Twin Cities MN | What you asking for the passenger side quarter panel or lower half of it? Inner fenders for front fenders? Gauges and speedo? I just picked up a 56 2 door hardtop basket case that has some rust and damage on right quarter and some of disassembled parts have deteriorated or been lost while it went through several previous owners. Needs a windshield also but don't know if 4 door hdtop interchanges on that or not. I want to put it back together as budget driver with DeSoto Hemi 330 engine I stumbled across locally that needed a home too. What part of Montana are you located in? I am in Minnesota. Thanks, Mike |
|
|
|
Veteran
Posts: 209
Location: The Republic of Texas | Can
i see the rear door panel trim please? |
|
|
|
Expert 5K+
Posts: 9900
Location: Lower Mainland BC | 56D500boy - 2016-12-19 1:46 AM
In my quest to convert the seldom used back-up lights on my 56 Custom Royal to extra tail/stop/signal lights, I need two proper OE bulb holders. I bought aftermarket sockets but they do not push the bulb out close to the lens. What I need is this (with a few inches of wire):
|
|
|