The Forward Look Network
The Forward Look Network
Search | Statistics | User Listing Forums | Chat | eBay | Calendars | Albums | Skins | Language
You are logged in as a guest. ( logon | register )

1960 Dodge D200 Power Giant work truck
Jump to page : 1
Now viewing page 1 [50 messages per page]
View previous thread :: View next thread
   Forward Look NON-Technical Discussions -> Members RidesMessage format
 
David Conwill
Posted 2017-09-06 2:07 PM (#547850)
Subject: 1960 Dodge D200 Power Giant work truck


New User

Posts: 1

I just acquired a 1960 Dodge D200 Power Giant work truck. It's a very basic vehicle with the Utiline step-side bed, L-head 230-cu.in. six cylinder, T85E three-speed, and 4.10 gears. It's currently missing the tailgate and the column shifter (someone installed a Hurst Indy floor shift). It also needs the fuel tank installed, a battery, a fuel-pump, radiator repair, and undoubtedly many other odds and ends from sitting.

My goals are to keep it very simple and stock. The only major change I have planned is I would like to install a New Process NP420 four-speed as it appears to be the simplest way to get a true floor-shift gearbox and it is very similar to the transmission on which I learned to drive, so it should be quite easy to teach my wife and daughters. I'm also thinking about throwing in a Pertronix Ignitor given the poor quality of modern points sets--though I'm tempted by the low cost of NOS/NORS points on eBay.

If anyone has any leads on a replacement radiator for less than $400, I'd greatly appreciate it. The unit that is currently on the car fell into the fan at some point and getting it re-cored appears to be prohibitively expensive. It also appears I will need new fuel-tank straps, though I anticipate that's more of a fabrication project than a parts hunt.

Thanks for looking!



(21441547_10215094440179513_1664876244_o.jpg)



Attachments
----------------
Attachments 21441547_10215094440179513_1664876244_o.jpg (307KB - 8 downloads)
Top of the page Bottom of the page
Powerflite
Posted 2017-09-06 6:46 PM (#547864 - in reply to #547850)
Subject: Re: 1960 Dodge D200 Power Giant work truck



Expert

Posts: 3390
20001000100100100252525
Location: So. California
Nice truck. Old trucks are the best for using to do actual work with them. Nice that you got 8 lug wheels in 1960. The wheels on my '57 D200 are large 6 lug style. The NP435 is a nice fully synchronized trans, but it uses an hydraulic clutch. I have one of those bell housings & flywheels kicking around for a small block. But my truck came with a 4-on the floor trans from the factory (but no synchro on 1st & 2nd) so I am going to just leave it there. I purchased a divorced gear vendor overdrive to go behind it so that I wouldn't have to mess with the 4.10:1 rear axle gears and be able to drive on the freeway faster than 60mph. I haven't installed it as of yet, because I haven't needed to use the truck as much as I had anticipated.
Top of the page Bottom of the page
Jump to page : 1
Now viewing page 1 [50 messages per page]
Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

Search for anything on eBay!

(Delete all cookies set by this site)