The Forward Look Network
The Forward Look Network
Search | Statistics | User Listing Forums | Chat | eBay | Calendars | Albums | Skins | Language
You are logged in as a guest. ( logon | register )

Linkage bushings
Jump to page : 1
Now viewing page 1 [50 messages per page]
View previous thread :: View next thread
   Forward Look Technical Discussions -> Engine, Exhaust, Fuel and IgnitionMessage format
 
MyMGs
Posted 2018-03-07 10:25 AM (#559394)
Subject: Linkage bushings


Member

Posts: 5

I am restoring a 1955 Dodge Lancer with the Powerflite transmission and i need the axcelerator bushings #14-11-20 Engine bracket with Bushing if that is the only way that it can be obtained and also the Body Bracket #14-11-20 with bushing if that is the only way the bushing can be obtained.

Does anyone know where i can just get the bushings and maybe i can just rebuild the linkage?
Thank you.

David
Top of the page Bottom of the page
56D500boy
Posted 2018-03-07 1:28 PM (#559402 - in reply to #559394)
Subject: RE: Linkage bushings



Expert 5K+

Posts: 9854
5000200020005001001001002525
Location: Lower Mainland BC
MyMGs - 2018-03-07 10:25 AM
I am restoring a 1955 Dodge Lancer with the Powerflite transmission and i need the axcelerator bushings #14-11-20 Engine bracket with Bushing if that is the only way that it can be obtained and also the Body Bracket #14-11-20 with bushing if that is the only way the bushing can be obtained.
David


14-11-20 is the section of the Parts Catalogue, not the part number per se. I think that the part numbers that you would need for the brackets are shown below, 1617 434 and 1617 132. As you can see, there were no sub-assembly parts, i.e. bushings. Therefore you will have to get creative and/or lucky and probably recreate the bushings out of a hard plastic like Delrin or oil-lite bronze.

Good luck.



(55-56ThrottleLinkagePartNumbers.jpg)



Attachments
----------------
Attachments 55-56ThrottleLinkagePartNumbers.jpg (209KB - 95 downloads)
Top of the page Bottom of the page
MyMGs
Posted 2018-03-07 3:25 PM (#559417 - in reply to #559394)
Subject: RE: Linkage bushings


Member

Posts: 5

Thank you very much 56d500boy for the response. I may be missing the point but one bracket and bushing mounts on the engine and one mounts on the body.
Do you have any idea how i would source these parts?

Thanks again

David MyMGs
Top of the page Bottom of the page
Jump to page : 1
Now viewing page 1 [50 messages per page]
Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

* * * This site contains affiliate links for which we may be compensated * * *


(Delete all cookies set by this site)