The Forward Look Network
The Forward Look Network
Search | Statistics | User Listing Forums | Chat | eBay | Calendars | Albums | Skins | Language
You are logged in as a guest. ( logon | register )

iron case torqueflite
Jump to page : 1
Now viewing page 1 [50 messages per page]
View previous thread :: View next thread
   Forward Look Technical Discussions -> General Technical Discussion and TroubleshootingMessage format
 
oliver
Posted 2019-07-17 5:26 PM (#584941)
Subject: iron case torqueflite


New User

Posts: 3

hello, i have a 58 dodge mayfair. the trans is a pushbutton 3spd. i have been trying to rebuild it. its all together but when reverse is engaged it will back up but drive forward when engine rpm is above 1000. it was a complete overhaul that included a new shift cable. anyone ever seen or heard of this?
Top of the page Bottom of the page
wizard
Posted 2019-07-18 1:49 AM (#584956 - in reply to #584941)
Subject: Re: iron case torqueflite



Board Moderator & Exner Expert 10K+

Posts: 11956
5000500010005001001001001002525
Location: Southern Sweden - Sturkö island
Internal leakages - most probably seal ring/s broken due to wear in the bore
Top of the page Bottom of the page
oliver
Posted 2019-07-18 7:59 AM (#584959 - in reply to #584941)
Subject: Re: iron case torqueflite


New User

Posts: 3

Thanks, I'll pull it back out and see what I find. Oliver
Top of the page Bottom of the page
oliver
Posted 2019-07-30 3:25 PM (#585393 - in reply to #584941)
Subject: Re: iron case torqueflite


New User

Posts: 3

thanks! the sealing rings that i had installed were not correct. i could not find any n.o.s. and gave up on aftermarket since the two sets i had purchased were not exactly the same. i just reused the originals and the trans shifts great.
Top of the page Bottom of the page
Jump to page : 1
Now viewing page 1 [50 messages per page]
Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread



(Delete all cookies set by this site)