|
|
Veteran
Posts: 295
| I was sandblasting my front break drums yesterday and I went to roll the anti-vibration springs so I could blast under them and POW...right in the kisser! Now I can't get it back on. I was telling my buddy about it and he wondered if they were needed at all anymore.
Do I need to put the anti-vibration spring back on the outside of the drum? And, if so, how the hell do I get it back on? I tried to roll it back on, not happening. Is there a tool or something?
Thanks,
Wayne |
|
|
|
Expert 5K+
Posts: 9855
Location: Lower Mainland BC | jaded13640 - 2020-06-15 2:22 PM Do I need to put the anti-vibration spring back on the outside of the drum? And, if so, how the hell do I get it back on? I tried to roll it back on, not happening. Is there a tool or something? Thanks, Wayne
Wayne: Don't feel bad. I did exactly the same thing, only on my left rear drum. This video should give you the needed hints to get it back on.
https://www.youtube.com/watch?v=FufAUoBohnQ
Good luck.
Let us know how it goes.
|
|
|
|
Veteran
Posts: 295
| Thanks, the video really helped. I figured that would be about the only way to get it back on but seeing him do it helped a lot.
Thanks again,
Wayne |
|
|
|
Expert
Posts: 1527
Location: ZH, Switzerland | On the front drums on my Letter the anti-vibration springs on the front drums are installed, but not at the rear drums... source? Make your own? |
|
|