The Forward Look Network
The Forward Look Network
Search | Statistics | User Listing Forums | Chat | eBay | Calendars | Albums | Skins | Language
You are logged in as a guest. ( logon | register )

accelerator linkage seal
Jump to page : 1
Now viewing page 1 [50 messages per page]
View previous thread :: View next thread
   Forward Look Technical Discussions -> Body, Glass, Interior and TrimMessage format
 
kcasey
Posted 2020-06-22 12:07 AM (#599991)
Subject: accelerator linkage seal


Veteran

Posts: 225
10010025
Location: fulshear texas
i know my 58 plymouth had some kind of seal where the accelerator pivot is on the floor but it is long gone. anyone have a good idea for a replacement? thanks
Top of the page Bottom of the page
LD3 Greg
Posted 2020-06-22 12:32 AM (#599993 - in reply to #599991)
Subject: RE: accelerator linkage seal


Expert

Posts: 1815
1000500100100100
Location: Ontario, Canada
There were several aftermarket boots available but they were too thick and simply didn’t work or even fit! I just used latex or nitrile surgical glove material and it is still working after 20 years!

Greg
Top of the page Bottom of the page
56D500boy
Posted 2020-06-22 1:53 AM (#599995 - in reply to #599991)
Subject: RE: accelerator linkage seal



Expert 5K+

Posts: 6256
500010001001002525
Location: Lower Mainland BC
kcasey - 2020-06-21 9:07 PM
i know my 58 plymouth had some kind of seal where the accelerator pivot is on the floor but it is long gone. anyone have a good idea for a replacement? thanks


Gary Goers used to sell them (something) so maybe Quirley's does now.

I made my own from a Mercury Marine throttle cable boot and a piece of EPDM rubber from a roof vent "jack"









REFERENCE: http://www.forwardlook.net/forums/forums/thread-view.asp?tid=66984&...

Top of the page Bottom of the page
FIN_NV
Posted 2020-06-22 11:48 AM (#600006 - in reply to #599991)
Subject: RE: accelerator linkage seal



Expert

Posts: 4585
20002000500252525
Location: Northern New Jersey
Gary Goers made them, at one time.
Top of the page Bottom of the page
kcasey
Posted 2020-06-22 11:09 PM (#600033 - in reply to #599991)
Subject: Re: accelerator linkage seal


Veteran

Posts: 225
10010025
Location: fulshear texas
thanks for the replies and the pics! now i'll get busy and make one.
Top of the page Bottom of the page
samstrader
Posted 2020-06-23 5:21 PM (#600063 - in reply to #600033)
Subject: Re: accelerator linkage seal


Veteran

Posts: 210
100100
Location: Beaumont TX
Attached is a picture of my accelerator seal. I'm almost certain this is original because the car has been in my family since purchased and it sat in a garage for years. I can't imagine it being replaced. You could use truck tire inner tube rubber or leather to make a new seal is looks like to me. But not sure.





(Untitled.jpg)



Attachments
----------------
Attachments Untitled.jpg (188KB - 19 downloads)
Top of the page Bottom of the page
Jump to page : 1
Now viewing page 1 [50 messages per page]
Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread



(Delete all cookies set by this site)