The Forward Look Network
The Forward Look Network
Search | Statistics | User Listing Forums | Chat | eBay | Calendars | Albums | Skins | Language
You are logged in as a guest. ( logon | register )

57 Plymouth Door Check Replacement
Jump to page : 1
Now viewing page 1 [50 messages per page]
View previous thread :: View next thread
   Forward Look Technical Discussions -> Body, Glass, Interior and TrimMessage format
 
JJG1214
Posted 2026-11-04 4:57 PM (#644717)
Subject: 57 Plymouth Door Check Replacement


Member

Posts: 13

Both doors on my Belvedere will not hold open - they freely swing shut. When working inside the car, I need to tie the doors open. A bit of a nuisance! :-( I assume the problem is that the door check arms are worn and the steel spring clips no longer can grab onto them? I can see quite a bit of wear on the bottom side of each arm.

I'm wondering how big a project is it to replace them? I see that the outside of the arm attaches to the body bracket on the door pillar with a rivet pin. Looks like I would need to drill it out from below in order to remove it. Then I would need to find a replacement rivet.

How does the other end of the door check arm attach inside the door? Is it easy to get at with the door panel off?

Any advice is appreciated! :-)
Top of the page Bottom of the page
Powerflite
Posted 2026-11-05 12:04 AM (#644718 - in reply to #644717)
Subject: Re: 57 Plymouth Door Check Replacement



Exner Expert 10K+

Posts: 10586
50005000500252525
Location: So. Cal
The other end is welded into the door frame. It's also difficult to get access to. They didn't make it easy to mess with that thing.
Top of the page Bottom of the page
miquelonbrad
Posted 2026-11-09 12:00 AM (#644730 - in reply to #644717)
Subject: Re: 57 Plymouth Door Check Replacement



Expert

Posts: 1746
100050010010025
Location: Hay Lakes, Alberta, Canada
I bought a pair of "rivets" that actually look like a rivet, but have a screw on the bottom side. Don't ask me where I bought them, as that was 15 years ago...

If you remove the door panel and access the check, you can remove it (after drilling the rivet).
Then you can bend/tighten the "clamp" the arm slides through. Also a good time to replace the rubber bumper if it's turned hard or is broken/missing.
Top of the page Bottom of the page
Jump to page : 1
Now viewing page 1 [50 messages per page]
Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

* * * This site contains affiliate links for which we may be compensated * * *


(Delete all cookies set by this site)