Re: [GFS] QUESTION FOR YOU ALL= BASE SIZE OF CARBS
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [GFS] QUESTION FOR YOU ALL= BASE SIZE OF CARBS



Hi Ron et al:

I agree with what has been said so far on the Fury 2x4 WCFBs and I can add 
something.

The aluminum manifold 1735919 has the "square" bolt pattern and the cast iron 
manifolds 1732479 and 1822004 have the "H" bolt pattern.  I suppose it may be 
possible to construct adapters to switch between manifolds.

I have the 1822004 manifold and carbs bolted on top of my 303 and they work 
fine except they seem to run a little rich.  I have been tinkering to try to 
lean them.  I have been collecting literature on the WCFBs and have lots of 
trivia about them for our 56-58 Furys.  Judging by the part number, the 1822004 
manifold is for later 318s.  It works well on earlier models since the engines 
were in many ways the same.

John Teske


[Non-text portions of this message have been removed]



 
Yahoo! Groups Links

<*> To visit your group on the web, go to:
     http://groups.yahoo.com/group/goldenfin/

<*> To unsubscribe from this group, send an email to:
     goldenfin-unsubscribe@xxxxxxxxxxxxxxx

<*> Your use of Yahoo! Groups is subject to:
     http://docs.yahoo.com/info/terms/
 




Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.