|
Jack: It's been a while, but as I remember, I got my body mount rubber from Steel. The "tall" one fits between the body and frame bracket. The smaller round section goes in the round hole on the frame bracket. The thinner rubbers and metal washers are used as shims to adjust body fit and as cushioning on the bottom of the bracket where the nut is placed on the bolt. I used new bolts for the body mount. At first I used what I found in the hardware store, but when tightening them, the heads of two snapped off. Therefore, I replaced all of them with grade 5 bolts. I didn't want the body going one direction and the chassis another while driving down the highway. By-by Fury. Hope this helps. John Teske ************************************** Get a sneak peek of the all-new AOL at http://discover.aol.com/memed/aolcom30tour __._,_.___
SPONSORED LINKS
Your email settings: Individual Email|Traditional
Change settings via the Web (Yahoo! ID required) Change settings via email: Switch delivery to Daily Digest | Switch to Fully Featured Visit Your Group | Yahoo! Groups Terms of Use | Unsubscribe __,_._,___ |
|
Back to the Home of the Forward Look Network