[GFS] 303 bore to std 318
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[GFS] 303 bore to std 318



I just got the results of the block soundings on one of my 303 56 Fury engines. The machine shop is telling me I will still have at least 1/8th inch of cylinder wall after boring the block the full 100 thousandths required to run stock 318 pistons. I figured that is would be ok, since I had bored my 318 57 Fury engine to a full 4 inches (+.090) back in the late 50’s and it worked out very well.

 

George

 

__._,_.___

Your email settings: Individual Email|Traditional
Change settings via the Web (Yahoo! ID required)
Change settings via email: Switch delivery to Daily Digest | Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | Unsubscribe

__,_._,___



Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.