RE: IML: Kitchen Table Specs for a frame hitch

["RODGER D. REDDISH" <fltsgt@xxxxxxx>]

Hola And Ah Ho Ho Ho Wayne

You can design the hitch and then go to a Metal Selling place in your area.  Purchace the stock and then cut it to the lenghts of your design.  Now drill and bolt all the joints.  Tote this to any welding shop and have them finish it.

 

If you feel this is a little over your area of expertise, copy the design of several "pick up trucks" to make it fit your car.

If any of you have a 1960 to 1966 car that has an hitch, send Wayne an direct email with photos and etc.

Rodger & Gabby

CO{S

 

---

From: Oneof514@xxxxxxx
Reply-To: mailing-list@xxxxxxxxxxxxxxxx
To: mailing-list@xxxxxxxxxxxxxxxx
Subject: IML: Specs for a frame hitch
Date: Thu, 7 Dec 2006 20:22:51 EST

I believe a few years ago someone posted information about how to fabricate a frame hitch for a body on frame Imperial (a 65 I think).  I searched the club archives and I was unable to find the thread.  Does anyone else recall this information?

Thank you,

Wayne Jorgensen

-----------------  http://www.imperialclub.com  -----------------
This message was sent to you by the Imperial Mailing List. Please 
reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be 
shared with everyone. Private messages (and attachments) for the
Administrators should be sent to webmaster@xxxxxxxxxxxxxxxx
To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm