IML: Excessive oil consumption
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

IML: Excessive oil consumption



I just finished a project, on a MB300 motor home engine,(440) the complaint was oil consumption, 1qt.per 800-1000 miles.If there is interest, I'll share the cures, and procedures. Ya'll have a nice day, Dave.
 
-------------- Original message --------------
From: sosmi@xxxxxxxxxxx
Ok, Dan, I'll give you another TRICK, most newer trans pans have a ring magnet in the pan, from the factory. 81 FSM, states it does. If you want to, you can take an old speaker, or some other magnet and simply put it on the bottom of the pan, near front right-hand corner. We also put one on the engine oil pan, near the drain plug.One more, is we use some magnetic sign material, around the oil filter.Since the oil pump sees the nasty stuff first, this helps save the pump from extra wear.Reuse the filter magnet, after oil change.Ya'll have a nice day, Dave.
 
-------------- Original message --------------
From: "Rob P" <fristpenny@xxxxxxxxxxx>

>
> When I read your subject I was expecting a trans rebuild. I've been wanting
> to do mine, but I'm a little scared. Changing the filter is messy, but not
> a big deal. I've done that on the street in Brooklyn. Get a big catch basin
> and funnel to pour the fluid in the dipstick tube. I'm with Kenyon, jack
> stands over ramps any day and you can't drive the car onto 4 ramps. Two
> would probably get it high enough, but not level.
>
> I wouldn't bother with the flush. If you are concerned about the fluid or
> it looks burned I'd just change it again at a really short interval. Pretty
> sure the 998s didn't have TC drain plugs. Don't go for a chrome pan. They
> are way more likely to leak. The MP pan, 500 pan or af termarket deep pan
> will allow a little more fluid and provide a drain plug to make the job
> easier, but you need to extend the pick up so the job is a little more.
> I've never used gasket sealer, just a little wheel bearing grease to hold
> the gasket in place. That's the way I was taught.
>
> Rob
>
> _________________________________________________________________
> Stay up-to-date with your friends through the Windows Live Spaces friends
> list.
> http://clk.atdmt.com/MSN/go/msnnkwsp0070000001msn/direct/01/?href=""
> live.com/spacesapi.aspx?wx_action=create&wx_url=/friends.aspx&mk
>
>
>
> ----------------- http://www.imperialclub.com -----------------
> This message was sent to you by the Imperial Mailing List. Please
> reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be
> shared with everyone. Private messages (and attachments) for the
> Administrators should be sent to webmaster@xxxxxxxxxxxxxxxx
> To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm
>


Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.