RE: IML: IMLTOO MUCH PRESSURE
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: IML: IMLTOO MUCH PRESSURE



Not so fast, the cooling system water passages in the head gaskets are not designed for 130 psi. On some of our Hi-performance boats, we had head gasket failure , on the water passages when we saw 30-40psi (85-100mph) in the cooling system. the cylinders did not fail.Ya'll have a nice day, Dave.
 
-------------- Original message --------------
From: "K. Eric Wolfe" <kewolfe@xxxxxxxxx>

Head gaskets should not be any problem as the manual calls for compression to run between 130 and 165 pounds (from the cylinder outward).   

 

-----Original Message-----
From: mailing-list-owner@xxxxxxxxxxxxxxxx [mailto:mailing-list-owner@xxxxxxxxxxxxxxxx] On Behalf Of Frederick Joslin
Sent: Tuesday, February 20, 2007 4:05 PM
To: mailing-list@xxxxxxxxxxxxxxxx
Subject: Re: IML: colling system pressure?

 

Just an idea. Can you bypass the radiator with a piece of hose of some description?

Also if you are worried about the pressure, try hooking up a compressor with the pressure regulated to less than 20 psi.  

----- Original Message -----
From: therichardsonfamily@xxxxxxxxxxx
To: mailing-list@xxxxxxxxxxxxxxxx
Subject: IML: colling system pressure?
Date: Tue, 20 Feb 2007 20:35:23 +0000


Here's a question for Dave, but others may have some insight as well.

My '67, 440 cid (Imperial engine) has newly
replaced freeze plugs, and a lot of casting
sand and junk in the cooling system. Prior to
doing a closed system flushing with "Cascade",
I want to get most of the garbage out using a
garden hose on the lower radiator hose, thereby
avoiding the redone radiator.

We all know 15-18 psi is what a radiator cap
opens at. However, my garden hose may be as
high as 25 to 30+ psi. Can the head gaskets,
etc. and inside of the engine take that kind of
pressure? Does anyone know what pressure
exists inside the block? O r would I be wiser
(with this old , tired engine) to just throw an
old radiator on and do a closed system flush?
Any other drawbacks to my open system flush?

Thanks for any input.

Dan Richardson
300L Family Heirloom


----------------- http://www.imperialclub.com -----------------
This message was sent to you by the Imperial Mailing List. Please
reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be
shared with everyone. Private messages (and attachments) for the
Administrators should be sent to webmaster@xxxxxxxxxxxxxxxx
To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm

 

Fred Joslin

 



Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.