Re: IML: '67 Carter carb flat spot
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: IML: '67 Carter carb flat spot



Driveway work shop, ha!  I'm a high class guy, I have a garage!!
 
Anyway, the Fannyometer seems to read good.  While I do get a chirp from the rear tires going into 2nd, I didn't break them loose like I thought I should from a dead stop.  After a bit more fine tuning, and a few more shots on the test track, I'll let you know how she's doing.
 
Dan Richardson
300L Family Heirloom
 
 
----- Original Message -----
Sent: Thursday, October 18, 2007 5:55 PM
Subject: Re: IML: '67 Carter carb flat spot

Not to over complicate the subject, early AFB carbs have no adjustments on the secondary air valve. It is a counter-weighted valve. The only way to change the opening vacuum is to remove the top of the carb, remove the valve and either grind the counter weight, for quicker response, or add solder to the weights to slow response(opening). This is something that few would contend with. The AVS, and new aftermarket AFB have the external adjustment air valve for the secondaries. This makes fine tuning much easier. Still the jet size prior to 89 (last of leaded gas) would be lean on todays gas. To correctly analyze this with electronics, would also require dyno time, not cheap. I venture to say, you could own two or more new carbs. The jet and rod kit is $50, the driveway work shop, and the all well know fannyometer, are a good place to start.Ya'll have a nice day, Dave.
 
-------------- Original message --------------
From: David Whitney <hazegreen66@xxxxxxxxx>
Unless you are aware of your A/F ratio you will be fumbling in the dark.  Try to find a performance tuning shop that will read the ratios and have a bunch of other stuff hooked up to the engine.  Your local Mopar club may be able to point you in the right direction.  The tuners will be able to make the proper jet/rod/spring combo recommendations.  Once you have that basic setup you can fiddle with it from there.  Otherwise any change you make could well send you in the wrong direction.  Ten to one they also find some other little things that will help you a lot.
 
From your initial post about having flatness between 1/3 and 2/3 throttle, it sounds like you are in the range where the secondaries should be opening.  So many things are happening at that RPM range that you need to have your A/F ratio correct before trying to adjust anything else.  You need to be sure that the linkage to the secondaries is adjusted to spec so they are opening when they should, and then you can fiddle with the adjustable secondary vacuum flap which governs the smooth transition from two to four barrels.  There is a delay between when the throttle plate opens and when gas actually starts to be pulled through the secondary barrels.  The stiffer your vacuum flap, the longer the delay.  That should be just a short bog, though, not a flat spot.
 
I concur that you are likely running lean, which is not a good thing with today's low octane gas and your high compression engine.  When in doubt, run a little rich.
 
 


Happy motoring,

David

'91 K-Imperial driver 200,000 miles
'66 LeBaron dual air and every option known to man


Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.