IML: Imperial Wheel Chock Dimensions
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

IML: Imperial Wheel Chock Dimensions



To the Group;

I reproduced a wheel chock for my '62 based on dimensions supplied by member Ken Miller some months ago.  The measurements are for the right angle sides;  5 3/8"  X 2 7/8".  The resulting sharp points are sanded down, leaving a rounded edge about 1/4" radius on the short side and about 3/16" radius on the long side.  The stock used is 4" X 4".  I used pressure treated pine and went to a friend who had a 12" blade miter saw with a laser beam feature.  That allowed us to position the 4 X 4 piece and get the penciled line I had drawn aligned perfectly.  A little extra work with a wood rasp and an electric sander finished the edges that needed to be rounded off.  The miter saw required two people to do the job, one to hold the material and another to operate the saw.  A band saw would probably be a better choice.  Be sure to use adequate safety precautions when doing this to avoid kickback of the material etc.  It could also be created using a hand saw, but it will take a while!  Use flat black acrylic paint to finish.

The finished product looks exactly as I remember seeing wheel chocks from '50s era Chrysler products.  Evidently Chrysler Corp. continued to provide these wheel chocks into the '60s at least.

Joe

begin:vcard
fn:Joe Strickland
n:Strickland;Joe
adr;dom:;;1021 Vaughan Lane;Tioga;Texasw;76271
email;internet:jwstrick426@xxxxxxxxxx
version:2.1
end:vcard



Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.