IML: cracked block

["William Miller" <abmiller@xxxxxxxxxxxx>]

Greetings All,

Cracks in cast iron can be repaired if there is enough thickness.  There is a business on line with a good web site.

Metal Locking Service Inc.  1-866.Fix Iron

Their fix is similar to what we did back in the 50's to repair cracks.  It worked for cracks in flathead valve seats.  Fix the crack, cut out for a replacement valve seat and grind for the correct angle, put it back together.

We would drill an 1/8" hole just behind the end of the crack, in good metal.  Then start drilling holes down the crack. Into each hole we drove a tapered steel pin coated with Litharge (PbO) and Glycerin.  Each hole drilled clipped the previous one, so there was a solid line of pins.  The above business taps each hole and screws  a pin into the hole.

The above fix was labor intensive but could rescue a block that could not be replaced.

Darn, I sound old when I bring something like this up.

 

Bill Miller

68 Crown 4dr HT

64 300K conv.