RE: IML: Rebuilding Budd Calipers

["TomChoice" <tcsibor@xxxxxxxxxxxxxxxx>]

Thanks Hailey,

I will try that. I know it's a big safety no-no, but I usually use
compressed air and a tapping hammer to free them up.

Tom


-----Original Message-----
From: mailing-list-owner@xxxxxxxxxxxxxxxx
[mailto:mailing-list-owner@xxxxxxxxxxxxxxxx]On Behalf Of Hailey (Morgan)
Moore
Sent: Friday, December 10, 2004 11:19 PM
To: mailing-list@xxxxxxxxxxxxxxxx
Subject: Re: IML: Rebuilding Budd Calipers


Yes. You need some silicone "rubber" grease that is rated for use on
brake rubbers. Grab it at NAPA or Car quest or whatever. smear your
seals and the cylinders with it, and they should just slide in. I have
had the problem several times. What's even more fun though is getting
them out when they are all stuck. I used a brake master cylinder from
some old british car that I got from a friend. I hooked up the line to
the caliper, and kept pouring in vegitable oil and pumping untill they
popped. This was after boiling them all day on the kitchen stove in a
big pot of water and viniger.

good luck

-Hailey


On Thu, 9 Dec 2004 22:11:38 -0800, TomChoice <tcsibor@xxxxxxxxxxxxxxxx>
wrote:
> Anyone know the secret to putting the pistons back into the caliper
> cylinders on the 4 piston 1968 Budd calipers when new piston seals are
used?
> I am having a heck of a time....
>
> Tom
>
> -----------------  http://www.imperialclub.com  -----------------
> This message was sent to you by the Imperial Mailing List. Please
> reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be
> shared with everyone. Private messages (and attachments) for the
> Administrators should be sent to webmaster@xxxxxxxxxxxxxxxx
> To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm
>
>


-----------------  http://www.imperialclub.com  -----------------
This message was sent to you by the Imperial Mailing List. Please
reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be
shared with everyone. Private messages (and attachments) for the
Administrators should be sent to webmaster@xxxxxxxxxxxxxxxx
To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm





-----------------  http://www.imperialclub.com  -----------------
This message was sent to you by the Imperial Mailing List. Please 
reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be 
shared with everyone. Private messages (and attachments) for the
Administrators should be sent to webmaster@xxxxxxxxxxxxxxxx
To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm