Re: [FWDLK] Steering Column
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [FWDLK] Steering Column



In a message dated 5/31/2005 10:53:32 AM Eastern Daylight Time, Chris_Hullinger@xxxxxxxxxxxxxxx writes:
I recently pulled the dash and interior pieces out of my '58 Coronet and
sent it to the paint shop for a freshen-up.  I've been able to pull
everything out without a problem except for the steering column.  It seems
that even though I loosened the two bolts that attaches to the steering
box, I'm only able to slide the column up about 2 inches.  The column will
rotate 360 degrees without difficulty but I can't seem to get it out all
the way.  The service manual doesn't provide much help either.  Any ideas
on how to get the column out so I can have it painted?
 
Does this question ever sound familiar....about 2 months ago I tried to remove my 58 300 D's column and asked the same question....No manual help and no one could answer my question.  Well Chris, look very closely at the shaft of your column at the upper bearing and you will see a very fine snap wire spring.  I refrain from calling it a snap ring because if it was, you would be able to see it very easily. The wire spring is very fine and has to be pulled out.  When you do the column will almost fall off. If you need more explanation please email me...
 
Marv Raguse 
 
 
   

*************************************************************

To unsubscribe or set your subscription options, please go to
http://lists.psu.edu/cgi-bin/wa?SUBED1=l-forwardlook&A=1




Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.