Re: [FWDLK] hemi plug wires
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [FWDLK] hemi plug wires



Thanx everyone for the help.  I have an aftermarket wire set with rubber insulators, hence the problem.  I'll get a pair of stork pliars.
 
--Roger van Hoy, Washougal, WA, '55 DeSoto, '58 DeSoto, '56 Plymouth, '66 Plymouth, '41 Dodge
----- Original Message -----
Sent: Tuesday, October 03, 2006 5:56 AM
Subject: Re: [FWDLK] hemi plug wires

Original hemi plug wire sets had ceramic insulator ends almost the length of the plug tubes through the valve covers into 1955.  During that year or certainly for the beginning of 1956, a switch was made from ceramic to a pinkish orange phenolic wire insulator.  Installation of the wire to the plug is insured when these are in place.  Standard ignition wire sets without insulators can probably only be installed with a VERY LONG pair of needle nose pliers.  Currently available aftermarket plug wire sets that are intended for hemis typically have some sort of silicone or quality rubber insulators that approximate the original ceramic / phenolic.  
Note that "exact" reproduction wire sets with "Mopar" inked onto them to make them "genuine" are a sales gimmick.  The factory wires were inked with "Auto-Lite", a part number and a date code.
 
Wayne

*************************************************************

To unsubscribe or set your subscription options, please go to
http://lists.psu.edu/cgi-bin/wa?SUBED1=l-forwardlook&A=1

*************************************************************

To unsubscribe or set your subscription options, please go to
http://lists.psu.edu/cgi-bin/wa?SUBED1=l-forwardlook&A=1




Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.