Re: [FWDLK] Vacuum advance
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [FWDLK] Vacuum advance



Just the absence of the vacuum advance shouldn't cause a failure of the ignition system, corrosion/rust could cause an overload though if it is in the points circuit. The points burning after a short time would indicate to me that the condenser was bad or of the wrong value. Changing the polarity of the battery will make the spark jump the opposite direction on the spark plug than it was designed for but shouldn't harm any of the components of the ignition system. When you change the vacuum advance out lubricate the advance mechanism so it will operate correctly with the new vacuum unit.
John

----- Original Message ----- From: "Nichols" <nick.barb@xxxxxxxxxxxxx>
To: <L-FORWARDLOOK@xxxxxxxxxxxxx>
Sent: Monday, September 03, 2007 9:50 PM
Subject: [FWDLK] Vacuum advance


I've discovered what I thought was a fuel starvation problem may be an ignition problem. The vacuum advance on my flathead 6 cylinder Plymouth engine is not working. I did a test from a good running car. I installed a long hose to the good running car and ran it to the problem car's vacuum advance hose and revved the engine on the good car and with the distributor cap off the problem car I noticed there was no movement of the breaker plate. I could also hear a leak from the diaphragm of the vacuum advance of the problem car. I plan to replace the vacuum advance.

Anyway, my question is this: Would a bad vacuum advance cause the engine to die intermittently? The car idles pretty well and actually accelerates fine but every so often the car will die at idle or when shifting from 1st to 2nd gear(three-speed manual trans.). Car will always restart. One other note: Someone had installed the battery wrong. The car is supposed to be positive ground and it was hooked up negative ground. I replaced the points after correcting the battery polarity but not the condenser. The points looked pretty fried after only being in the car for one week. Would incorrect polarity ruin the condenser and or the coil?


Any thoughts greatly appreciated.   Nick Nichols

*************************************************************

To unsubscribe or set your subscription options, please go to
http://lists.psu.edu/cgi-bin/wa?SUBED1=l-forwardlook&A=1



*************************************************************

To unsubscribe or set your subscription options, please go to
http://lists.psu.edu/cgi-bin/wa?SUBED1=l-forwardlook&A=1



Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.