Re: [FWDLK] dual masters-
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [FWDLK] dual masters-



In 1966 Disc Brakes were an option and even had special Hub Caps with Disc Brakes shown on them.
My 1966 300 Convertible had standard drum brakes on the front.
Ray in Mena



On Fri, Aug 8, 2014 at 7:40 PM, Dave Homstad <dhomstad@xxxxxxxxxxx> wrote:
Dan,

Not necessarilly. Chrysler may have installed a residual check valve as a separate item on the rear brake lines.

Dave Homstad
56 Dodge D500 


On Fri, Aug 8, 2014 at 9:45 AM, Dan Reitz wrote:

 Dave:
 
If what you say is true, then Chrysler goofed in 1966 when they produced my  1966 300.  They installed 4-piston disc brakes and a single MC.  I  have since changed them out to later model discs and a dual MC (with the  residual check valve removed.).  Brakes work wonders now.  Also, my  turning radius is smaller.  The original 4-piston discs would make great  boat anchors, they are heavy!!
 
Dan Reitz
 
 
In a message dated 8/8/2014 12:03:30 A.M. Pacific Daylight Time,  dhomstad@xxxxxxxxxxx writes:
Dan,

The reason the Installation of front disk brakes does require    installation of a dual master cylinder:
Drum brake systems are designed to hold some residual pressure at    the wheel cylinders to reduce the reaction time and pedal travel against the    brake springs. This is done in the master cylinder with a check valve. Disk    brakes have no retraction springs and any residual pressure will result in    constant light pressure of the disks against the rotors. Dual masters are    different for drum/drum, disk/drum, and disk/disk systems.

Dave Homstad
56 Dodge D500 


On Thu, Aug 7, 2014 at 11:35 PM, Daniel Davids    wrote:

  Installation of front disk brakes does NOT    require installation of a dual master cylinder.


What IS required is a means of balancing the braking power between    front and rear, because you’ve massively changed the pressure and response    characteristics of the front system.
This is accomplished simply by putting an adjustable proportioning    valve between the front and rear lines. Cheap and available through Summit    Racing, JEGS, or whomever. In the case of cars that came with    factory-installed disk brakes, there is a proportioning block, which does the    same thing as the aforementioned valve, except that it is not adjustable. The    engineers figured out the correct orifice sizing for that particular car and    spec’d it for manufacture.


I used to drive formula race cars which had a driver-controllable    brake proportioning valve. The master cylinders were single.


Dan Davids









On Aug 7, 2014, at 2:33 PM, Neil Vedder < esierraadj@xxxxxxxxxxx> wrote:

Thanks, Dave; the English tea cookie is also shown.

Then, the owner still has to re-plumb the brake system....and    put-up
with the Dualie's appearance, once it is installed.

All for what purpose?

A Dualie is not going to improve any braking response/reaction,    but, if
someone is installing disc brakes, a Dualie is a necessary evil.

I get that, and it's part of the protocol.

You want to do something good for your car's braking?

Replace its TIRES with new ones.

Tires, for the past few years, have been built with    life-expectancies of
about 6-8 years.

How about THIS for a new thread???

Bias ply -vs- radials!!!

Neil Vedder




*************************************************************
To unsubscribe or set your subscription options, please go to

*************************************************************
To unsubscribe or set your subscription options,    please go to

*************************************************************
To unsubscribe or set your subscription options, please go to

*************************************************************

To unsubscribe or set your subscription options, please go to
http://lists.psu.edu/cgi-bin/wa?SUBED1=l-forwardlook&AMP;A=1

Help The Forward Look with every Amazon purchase by clicking here!
Help the Forward Look with every eBay purchase by starting your search here!




--
Ray Jones. Y'all come on down an see us. Ya hear?

*************************************************************

To unsubscribe or set your subscription options, please go to
http://lists.psu.edu/cgi-bin/wa?SUBED1=l-forwardlook&A=1

Help The Forward Look with every Amazon purchase by clicking here!
Help the Forward Look with every eBay purchase by starting your search here!




Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.