|
The 57 truck service manual for the 315 says "the
stamped arrow on the tube indicates the oversize bolt hole-upper side
only"
Sent: Wednesday, November 18, 2015 5:09 PM
Subject: [FWDLK] Rocker Shaft Installation in 1957 Dodge 325
Engine
Three years ago I had the 325 V8 engine of my 1957 Dodge
Custom Royal rebuilt. Since then, I have regularly been going through
pushrods at the rate of one every one to two months during the driving
season. It’s a problem I’ve never experienced before the rebuild.
I’m sure this is caused by improper oil distribution to the rocker arms, but
I’ve been unable to confirm it.
I need a foolproof way to ensure proper rocker shaft
installation so the oil gets to where it needs to be. Can anyone confirm
the correct orientation of the little arrow on each rocker shaft to ensure
proper installation? Any pictures of this that would be helpful?
Thanks for your help!
John Williams
No virus found in this
message.
Checked by AVG - www.avg.com
Version: 2016.0.7227 / Virus
Database: 4460/11025 - Release Date: 11/18/15
*************************************************************
To unsubscribe or set your subscription options,
please go to
http://lists.psu.edu/cgi-bin/wa?SUBED1=l-forwardlook&A=1
Help The Forward Look with every Amazon purchase by clicking
here!
Help the
Forward Look with every eBay purchase by starting your search
here!
*************************************************************
To unsubscribe or set your subscription options,
please go to
http://lists.psu.edu/cgi-bin/wa?SUBED1=l-forwardlook&A=1
Help The Forward Look with every Amazon purchase by clicking here!
Help the Forward Look with every eBay purchase by starting your search here!
| 
Back to the Home of the Forward Look Network