Terry -
Has the pedal always been low, or just since you did the
brakes ? It's critical to know this before we can give you advice.
Ron
----- Original Message -----
Sent: Thursday, July 31, 2014 8:23
PM
Subject: [Chrysler300] 300F Brakes
Again!
Terry McTaggart here in Dayton OH. New wheel cylinders, new master
cylinder, new fluid, linings are great, all done by my local shop. And I
myself jacked the car up and adjusted all the brakes. Car stops fine,
but the pedal is low. Shop manual says the adjustment for this is the
pushrod from the brake assembly thru the firewall into the master cylinder.
But my car has a one-piece push rod, so there is no adjustment. So
Murray Park sent me the correct two-piece pushrod. Inside the car, I
disconnected the current pushrod from the brake pedal, but when I
attempted to slide the pushrod out, it would not come out, even when I used
considerable force. Looking at the manual, it should just slide out.
Anybody got any ideas as to why it won't come out?
__._,_.___
Posted by: "Ron Waters" <ronbo97@xxxxxxxxxxx>
To send a message to this group, send an email to:
Chrysler300@xxxxxxxxxxxxxxx
To unsubscribe from this group, send an email to bob@xxxxxxxxxxxxx or
go to http://autos.groups.yahoo.com/group/Chrysler300/join and select the "Leave Group" button
For list server instructions, go to http://www.chrysler300club.com/yahoolist/inst.htm
For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang
![]()
__,_._,___
|
Back to the Home of the Forward Look Network
Archive Sitemap