Re: [Chrysler300] 300F pass quarter (and
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Chrysler300] 300F pass quarter (and





I can't say how well it would come out on an F, but it worked extremely well on my C. I bought a pair of 4-door Saratoga quarter panels from Jeff Carter because of extensive rust issues on my entire lower quarters, and we used roughly the lower half of each of them.Having the original stamped wheel openings of the 4-door saved a ton of work and looks perfect.

Keith Boonstra

-

On Wed, Sep 2, 2015 at 9:15 AM, 'Rick Vitek' rpvitek@xxxxxxxxxxxxx [Chrysler300] <Chrysler300-noreply@xxxxxxxxxxxxxxx> wrote:
 

I realize Mr Grady is looking for a complete panel but it raises a question
I've been meaning to ask. If one were just looking for the metal around the
rear wheel well opening to repair rust damage would the wheel well opening
metal from a four door work? The metal at the front of the opening would be
limited due to the proximity of the door but otherwise is the opening size
and contour the same? The opening on a G I'm working on was stabilized by a
previous owner's good work with some fiberglass. But if I ran across a good
panel from a four door is it useable for that section? Would openings from
other Chrysler cars of that year (Windsor, Newport, etc.) be the same? If so
given the somewhat modest body restyling for '62 would those four doors have
the same rear openings as the '61's ? A lot to ask but I imagine someone has
previously looked into this.

Thanks in advance.

From: Chrysler300@xxxxxxxxxxxxxxx [mailto:Chrysler300@xxxxxxxxxxxxxxx] On
Behalf Of 'John Grady' jkg@xxxxxxxxxxxxxxxxx [Chrysler300]
Sent: Tuesday, September 01, 2015 12:02 PM
To: Chrysler300@xxxxxxxxxxxxxxx
Cc: 'Jean-Yves Chouinard'
Subject: [Chrysler300] FW: 300F pass quarter

Hi all, ,

We need a 60 Chrysler passenger side quarter panel from convert (right) or
coupe ; restoring a real terra cotta F, had been hit, we found half xxx 4
door quarter panel had been grafted on 30 years ago + , does not fit right,
they made new fender lip of solid bondo ( not rusted there!) . As result of
poor body work, trunk lid fit awful. Wheel well rippled/crushed, left like
that.

I have a hope someone paring down the pile (me too!) has a clip or a pass
side panel hanging on a wall..with a wheel well..??

Obviously, tried the usual suspects , no luck.

Any help greatly appreciated,

John

[Non-text portions of this message have been removed]




__._,_.___

Posted by: Keith Boonstra <kboonstra.zeegroup@xxxxxxxxx>


To send a message to this group, send an email to:
Chrysler300@xxxxxxxxxxxxxxx

To unsubscribe from this group, send an email to bob@xxxxxxxxxxxxx or
go to https://groups.yahoo.com/neo/groups/all/manage/edit

For list server instructions, go to http://www.chrysler300club.com/yahoolist/inst.htm

For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang




Visit Your Group
Yahoo! Groups
PrivacyUnsubscribeTerms of Use

__,_._,___


Home Back to the Home of the Forward Look Network Archive Sitemap


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.