Re: [Chrysler300] 64 trans. conversion?
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Chrysler300] 64 trans. conversion?

I think you want a '65 trans for that type of conversion. Contact these guys to see if yours can be converted.
A&A Transmissions
5061 E N County Line Road
Camby, IN  46113

(317) 831-3066
Good luck, 
Mike Laiserin
-----Original Message-----
From: Dave Dumais dave.dumais@xxxxxxxxx [Chrysler300] <Chrysler300-noreply@xxxxxxxxxxxxxxx>
To: yahoogroups <chrysler300@xxxxxxxxxxxxxxx>
Sent: Wed, Jan 13, 2016 4:34 pm
Subject: [Chrysler300] 64 trans. conversion?

Greetings All,

Can a 64 300 -727 be converted to a "slip in" drive shaft yoke and boot for a non 300 application?

And, will the 64 crank shaft flange mate to a flex plate, even though it was a 4 spd. engine?                 6 bolts on rear flange.

Stay warm


Posted by: Mwl1967 <mwl1967@xxxxxxx>

To send a message to this group, send an email to:

To unsubscribe from this group, send an email to bob@xxxxxxxxxxxxx or
go to

For list server instructions, go to

For archives go to


Home Back to the Home of the Forward Look Network Archive Sitemap