Re: [Chrysler300] 300 G Grille Emblem
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Chrysler300] 300 G Grille Emblem

I did almost the exact same thing except that I soldered the bolts to the plate. Works like a charm and if I need to replace the grill the emblem is easily removed.

Charlie Valentine

Sent from Yahoo Mail on Android

On Thu, Aug 11, 2016 at 9:59 AM, dan300f@xxxxxxx [Chrysler300]
<Chrysler300-noreply@xxxxxxxxxxxxxxx> wrote:

Hi all:
Years ago,  decided to replace the grill emblem of my F with a new one.  It seems like it took 2 men and a boy to remove the old one.  So I decided on a method to install the new one so that I could remove it easily if need be.  I took a piece of sheet metal, cut it to the shape of the emblem and pounded it to the spherical shape of the back side of the emblem.  Next, I drilled two holes in the grill where the emblem would be mounted.  I soldered two small bolts, with the heads ground down to almost nothing, so that the position of the bolts matched the ones I drilled in the grill.  I then used JB Weld to mount the emblem to the metal I had fashioned.  After the JB Weld had cured, I mounted the assembly to the grill.  It's been there now for perhaps 15 years.  The JB Weld has not damaged the backing of the emblem.
Dan Reitz
Bell Canyon, CA


Posted by: Charlie V <cv300g@xxxxxxxxx>

To send a message to this group, send an email to:

To unsubscribe from this group, send an email to bob@xxxxxxxxxxxxx or
go to

For list server instructions, go to

For archives go to

Visit Your Group
Yahoo! Groups
PrivacyUnsubscribeTerms of Use


Home Back to the Home of the Forward Look Network Archive Sitemap