Re: [Chrysler300] Chrysler 300H - Engine rear / trans support parts - 41
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Chrysler300] Chrysler 300H - Engine rear / trans support parts - 413 w / automatic trans


I was looking on-line for some motor mounts for my K.  Atlas Obsolete shows a complete set of motor months, including the transmission mount; which I believe is the part you are looking for.  Hope this helps.


On Sep 14, 2016 10:29 PM, "'Carlton Schroeder' schroe99@xxxxxxxxxxxx [Chrysler300]" <Chrysler300-noreply@xxxxxxxxxxxxxxx> wrote:


I’ve not had luck finding a few parts (searching on-line) I need for the trans mount assembly and hope someone has found a source.   From my parts book diagram it is called a stop (9-71-15) which I think translates to part no. 2201989; it looks like a large rubber grommet.  The other part is described as a stud / washer (9-71-18) which translates to part no. 2201985; it looks like a shoulder bolt but also has two washers that probably go on each side of the grommet-like stop.

Any help or suggestions will be appreciated.


Carlton Schroeder

Eagle River, WI     


Posted by: Bill Elder <belder1971@xxxxxxxxx>

To send a message to this group, send an email to:

To unsubscribe from this group, send an email to bob@xxxxxxxxxxxxx or
go to

For list server instructions, go to

For archives go to

Visit Your Group
Yahoo! Groups
PrivacyUnsubscribeTerms of Use


Home Back to the Home of the Forward Look Network Archive Sitemap