Re: [Chrysler300] Chrysler 300H - Engine rear / trans support parts - 41
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Chrysler300] Chrysler 300H - Engine rear / trans support parts - 413 w / automatic trans

Hey all,
There's a place called Then and Now that remakes your old mounts. $77.00 a pair of motor mounts. I'm sure they do trans mounts. They are located in Weymouth, MA.
D Cole

Sent from my iPhone

On Sep 15, 2016, at 2:43 AM, Bill Elder belder1971@xxxxxxxxx [Chrysler300] <Chrysler300-noreply@xxxxxxxxxxxxxxx> wrote:



I was looking on-line for some motor mounts for my K.  Atlas Obsolete shows a complete set of motor months, including the transmission mount; which I believe is the part you are looking for.  Hope this helps.


On Sep 14, 2016 10:29 PM, "'Carlton Schroeder' schroe99@xxxxxxxxxxxx [Chrysler300]" <Chrysler300-noreply@xxxxxxxxxxxxxxx> wrote:


I’ve not had luck finding a few parts (searching on-line) I need for the trans mount assembly and hope someone has found a source.   From my parts book diagram it is called a stop (9-71-15) which I think translates to part no. 2201989; it looks like a large rubber grommet.  The other part is described as a stud / washer (9-71-18) which translates to part no. 2201985; it looks like a shoulder bolt but also has two washers that probably go on each side of the grommet-like stop.

Any help or suggestions will be appreciated.


Carlton Schroeder

Eagle River, WI     


Posted by: Don Cole <mr300k@xxxxxxxxx>

To send a message to this group, send an email to:

To unsubscribe from this group, send an email to bob@xxxxxxxxxxxxx or
go to

For list server instructions, go to

For archives go to


Home Back to the Home of the Forward Look Network Archive Sitemap