Re: [Chrysler300] 64 tailpipe brackets
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Chrysler300] 64 tailpipe brackets

Dave, 300 List
The long exhaust manifolds for the Short long ram, require support to hold up the exhaust pipe. If installing the pipe without proper support, the four bolt flange at the connection can break, from what I've heard somewhat easily. Can anyone send a picture of these supports for the exhaust / tailpipe "Installed", and possibly a dimensioned sketch, with mounting points. Any assistance is Greatly appreciated! I think this question fits in this "64 Tailpipe brackets" string, Thanks again!  
Best Regards,
Stephen A. Noia
1-408-210-4736 cell

On Sunday, February 5, 2017 12:03 PM, "Dave Dumais dave.dumais@xxxxxxxxx [Chrysler300]" <Chrysler300-noreply@xxxxxxxxxxxxxxx> wrote:

Thanks for all the support on the K tail pipe hangers.

I found them as B body, the rubber straps need to measure up to your pipe.

From Accurate Exhaust, in the state of Oregon.

And this is the last I'll say about them.

Thanks again,

Dave in VA.


Posted by: Anna F Noia <sa-noia@xxxxxxxxxxx>

To send a message to this group, send an email to:

To unsubscribe from this group, send an email to bob@xxxxxxxxxxxxx or
go to

For list server instructions, go to

For archives go to

Visit Your Group
Yahoo! Groups
PrivacyUnsubscribeTerms of Use


Home Back to the Home of the Forward Look Network Archive Sitemap