RE: [Chrysler300] 61 300G
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: [Chrysler300] 61 300G



You've got to pull the compressor to read the numbers, that's the only place they are.  As far as the seat goes, you need to get that switch working, trying to move the seat any other way will cause damage.


Bob J

300G, Danville CA


From: Chrysler300@xxxxxxxxxxxxxxx [mailto:Chrysler300@xxxxxxxxxxxxxxx] On Behalf Of 'Michael Ashmore' michael.ashmore@xxxxxxx [Chrysler300]
Sent: Tuesday, September 05, 2017 9:01 AM
To: Chrysler 300 Club Int. Server <chrysler300@xxxxxxxxxxxxxxx>
Subject: Re: [Chrysler300] 61 300G



Another question for the experienced!


300G,  Is there any way to view the engine ID numbers on AC cars without removing the compressor/brackets?  Is there engine ID stamps anywhere else on the block?


Also is there any way you can move a power driver seat when the switch isn't working?  I wouild like to move the seat back manually if possible.


Thanks for all the help so far.


Mike 300G

----- Original Message -----

Sent: Saturday, August 26, 2017 7:47 PM

Subject: [Chrysler300] 61 300G



Hi All,


Now that I've sold my 61 Corvette my 61 300G gets all the attention!




1. What width size whitewall did the 300G come with?  I'm planning on buying Coker radials, The stock size was 8.00 - 15.  Would that equate to 225 70R-15?


2. I also need to do the brakes from stem to stern.  I was going to use NAPA for most of the parts.  Comments?  Recommendations?  Has anyone used s/s brake lines from Good Brakes or Brake Hoses Unlimited on EBay?



Mike  300G Barn Find


Posted by: "Bob Jasinski" <rpjasin@xxxxxxxxxxx>

To send a message to this group, send an email to:

To unsubscribe from this group, send an email to bob@xxxxxxxxxxxxx or
go to

For list server instructions, go to

For archives go to


Home Back to the Home of the Forward Look Network Archive Sitemap