RE: [Chrysler300] Window mechanism bites owner-tech
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: [Chrysler300] Window mechanism bites owner-tech





Exactly.  We can’t repeat this often enough.  Message from the past:

 

There are three kinds of men. The one that learns by reading. The few who learn by observation. The rest of them have to pee on the electric fence for themselves. Will Rogers

So, work on being the first kind and keep reading the (mostly) wisdom found at this site.

 

Rich Barber

Brentwood, CA

 

 

From: Ray Jones [mailto:1970hurst@xxxxxxxxx]
Sent: Sunday, December 24, 2017 5:49 PM
To: Rich Barber <c300@xxxxxxx>
Cc: Chrysler 300 Club Int. Server <chrysler300@xxxxxxxxxxxxxxx>; Ray Jones <1970hurst@xxxxxxxxx>
Subject: Re: [Chrysler300] Window mechanism bites owner-tech

 

I said I knew about the spring.

My learning experience...

I had the regulator out of the door with the motor still attached.

On the bench, I removed the 3 bolts holding the motor and went to lift off the motor.

As soon as it came clear of the gear, the lift arm violently swung around and the object that stopped it was my forehead, I still have a slight dent there. Only thing that saved me from a real disaster was the regulator was not attached to anything and when the arm hit my noggin, the regulator flew off the bench.

 

This is why I always secure the arm to the frame of the regulator.

Also, there is no index for where the motor is installed. put it on the frame and bolt it tight.

The motor does not care where it is, will run to lift or lower until it is stalled..

 

Ray

 

On Sun, Dec 24, 2017 at 7:39 PM, 'Rich Barber' c300@xxxxxxx [Chrysler300] <Chrysler300-noreply@xxxxxxxxxxxxxxx> wrote:

 

A response for an unnamed friend.  Remember this before you start working on automobile window regulators/lifting mechanisms.  Stored energy in a wound-up spring has no conscience.

 

Rich, one of the dumber things I did years ago was to repair the switch in our 72 Town and Country. The door switch was not working.   had the door cover removed and was working inside the inner frame without being able to see what was going on. Repair by Braille. As you can guess the spring slipped of the motor end and very nicely nearly took of the middle finger at the first joint. Pulled the hide down to the next joint and required 19 stitches to bring every thing back to normal. I decided that any further switch repair would be done by an expert. Haven't needed this yet but the reminder is very clear in my mind.

Thanks for sharing, friend!

Counting blessings this Christmas eve,

Rich Barber

Brentwood, CA

 

 

 




--

Ray Jones. Y'all come on down an see us. Ya hear?



__._,_.___

Posted by: "Rich Barber" <c300@xxxxxxx>


To send a message to this group, send an email to:
Chrysler300@xxxxxxxxxxxxxxx

To unsubscribe from this group, send an email to bob@xxxxxxxxxxxxx or
go to https://groups.yahoo.com/neo/groups/all/manage/edit

For list server instructions, go to http://www.chrysler300club.com/yahoolist/inst.htm

For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang





__,_._,___


Home Back to the Home of the Forward Look Network Archive Sitemap


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.