|
I have the same situation please include me an any reply’s Thank You Larry From: chrysler-300-club-international@xxxxxxxxxxxxxxxx <chrysler-300-club-international@xxxxxxxxxxxxxxxx>
On Behalf Of rob
Hello 300 Group About three months ago after a nice Sunday drive I discovered my LETTER “S” on the hood nose of my 300 had disappeared. I suspect it just fell out. I was able to find a replacement S from the Quigly company. It is not chromed…but it will do. Then I learned I needed a set of spring clips to properly attach it. I was able to get the spring clips…a set of 8! Now the challenge of how to properly install it? I tried putting it in the hole and gently tapping the clip. This did not work adequately. Then I tried attaching it first to the post of the letter and gently tapping that into the hole. This resulted in the post on the letter bending. Any advice on how to properly install my new letter. I did think about using adhesive…. however the proximity to the radiator leads me to believe an adhesive will fail due to the heat. I will be grateful for some good advice? Here’s a few photos…. Thanks. Rob -- For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang --- You received this message because you are subscribed to the Google Groups "Chrysler 300 Club International" group. To unsubscribe from this group and stop receiving emails from it, send an email to chrysler-300-club-international+unsubscribe@xxxxxxxxxxxxxxxx. To view this discussion on the web visit https://groups.google.com/d/msgid/chrysler-300-club-international/8f136bc4a30749ab8fddf4b48111c2d1%40pwbsfo.com. |
Back to the Home of the Forward Look Network
Archive Sitemap
