{Chrysler 300} Ball Joint Follies
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

{Chrysler 300} Ball Joint Follies



You know, sometimes this hobby is just not fun.

 

I have NOS upper control arms. I have two new ball joints. NOS control arms do not have any threading in them, the first ball joints installed cuts the threads. I have the miller socket for the ball joint.

 

So, I go to thread it in, and it will not go down even using my impact driver. It goes about 75% in and then will not go in more. So, I pull it out, take a small wire brush and clean out any swarf and try again. I then add Rapid Tap oil. I end up getting it in and down and torqued to 125 after four or five cyclers of in-out-clean-again. I pull it out and clean up the thread sone last time and then put it in and torque it. Ok. One down.

 

Now, I take the second control arm. This time I go to put it in, and it feels like mush. I can get it down just using the torque wrench. It seats but will not torque down and I can see it starting to dig into the flange on the control arm. I pull it out and it has barely cut in any threads. I did not measure the two smooth bores on the NOS control arms to see if they were the same.

 

So, I happen to have one NOS ball joint that came with one the arms I got from Dave. I fish it out and go to screw it in and it goes in hard like the first one. Not quite as hard. I do the in and out thing and wipe the swarf and then get it down all the way. I then torque it and it torques down fine.

 

The only real explanation is that the Q&A on the ball new ball joint threads is bad. One ball joint is either deeper than the other or the NOS control arm bores were not very close.  I would guess it was the ball joint is the problem given that the NOS ball joint went in fine.

 

I am bothering to write this so that people know. You could get a set of new ball joints and screw them in, and they may not torque to 125. If someone uses the impact driver and does not double check it with a good torque wrench, you could end up with stripped threads in the control arm.

 

Beware.

 

James

--
For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang
---
You received this message because you are subscribed to the Google Groups "Chrysler 300 Club International" group.
To unsubscribe from this group and stop receiving emails from it, send an email to chrysler-300-club-international+unsubscribe@xxxxxxxxxxxxxxxx.
To view this discussion on the web visit https://groups.google.com/d/msgid/chrysler-300-club-international/CY5PR19MB617153DA3B1AD42981E4A22293FBA%40CY5PR19MB6171.namprd19.prod.outlook.com.


Home Back to the Home of the Forward Look Network Archive Sitemap


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.