{Chrysler 300} Ball Joint Help
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

{Chrysler 300} Ball Joint Help



Hi all,
 
I have been trying for two hours to get the right-side ball joints off the spindle (upright).  I have the factory Miller tool. I have pickle forks. I have a tie rod press off tool. Nothing is working.
 
I removed the entire assembly, the upper control arm, the lower control arm, all still attached to the spindle. 
 
I placed it on the bench and tried some heat. Nothing.
 
I have not yet attempted the left side, but I am assuming that I will run into the same.
 
One does not want to get too aggressive with pickle forks as one can bend the spindle arms.
 
So, has anyone any advice. This is stopping my rebuild of the 300K front end dead in its tracks? I have this week free to get it done.  Help?
 
Thanks, James.
 

--
For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang
---
You received this message because you are subscribed to the Google Groups "Chrysler 300 Club International" group.
To unsubscribe from this group and stop receiving emails from it, send an email to chrysler-300-club-international+unsubscribe@xxxxxxxxxxxxxxxx.
To view this discussion on the web visit https://groups.google.com/d/msgid/chrysler-300-club-international/CY5PR19MB61712DC8AB3320E0EC011DB493352%40CY5PR19MB6171.namprd19.prod.outlook.com.


Home Back to the Home of the Forward Look Network Archive Sitemap


Copyright The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.