hi Carlton The factory ground wire is under screws that only go into plastic ,holding the sheet metal gauge support That is NG , but put it in anyway What I do is solder a wire to the gauge support sheet metal before assembly ( need 250 weller gun or larger iron) It is tern plated solders easily if cleaned/ scraped - leave a few feet for now then later put eye on end ground to dash lip with screw or under a screw already there Aggravating problem , screws in plastic are often stripped you lose ground . Not just lights but even worse ground is also for gauge Voltage regulator . No ground can burn out all your gauges as it does not regulate the 12 to 5 average volts ( pulsing) without a ground best regards John
On Jul 21, 2025, at 6:02 PM, schroe99@xxxxxxxxxxxx wrote:
Hi John, Can you send me your email with the details where you recommend an additional ground wire for the astrodome system on the 62H. My dash is still on the bench awaiting testing to assure everything is OK before installation in my car. Thank you, Carlton
--
For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang
---
You received this message because you are subscribed to the Google Groups "Chrysler 300 Club International" group.
To unsubscribe from this group and stop receiving emails from it, send an email to chrysler-300-club-international+unsubscribe@xxxxxxxxxxxxxxxx.
To view this discussion visit https://groups.google.com/d/msgid/chrysler-300-club-international/B53311E2-7C0E-4D4E-9AEE-DFC2EEB819FB%40gradyresearch.com.
|
