If it's in a running car the trans and torque converter would have to come out. Then look at the end of the crank there will be a large hole where the center of the torque converter/flywheel fits in and rests then deeper in the crank there is a smaller hole for the pilot bushing. Chuck Sent from my Galaxy -------- Original message -------- From: neal zimmerman <neal.zimmerman@xxxxxxxxx> Date: 9/7/22 7:53 PM (GMT-05:00) To: 1962to1965mopars <1962to1965mopars@xxxxxxxxxxxxxxxx> Subject: pilot bushing dos and donts how can one tell if a 440 crank is machined for a pilot bushing ? And if it is not, would it require disassembling the engine to do so?
-- neal zimmerman -- -- Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks! 1962 to 1965 Mopar Clubhouse Discussion Guidelines: http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html. -- You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group. http://groups.google.com/group/1962to1965mopars?hl=en. --- You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group. To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxx. To view this discussion on the web visit https://groups.google.com/d/msgid/1962to1965mopars/CANQhizQ_BQe9aOx5%3DS%3D%2B4nwD-rHEGG2wzqJ4BwSn%2BetV_AhY5g%40mail.gmail.com. -- -- -- Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks! 1962 to 1965 Mopar Clubhouse Discussion Guidelines: http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html. -- You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group. http://groups.google.com/group/1962to1965mopars?hl=en. --- You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group. To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxx. To view this discussion on the web visit https://groups.google.com/d/msgid/1962to1965mopars/63193d20.c80a0220.52d2d.ed13%40mx.google.com. |
Back to the Home of the Forward Look Network