RE: Exhaust studs?

[Sean B <polecat2@xxxxxxxx>]

Gary,

I know they are 3/8, coarse on the head side and fine thread on the 
manifold side.  I don't know the length, but I took one to NAPA and they 
had one about as exact as can be.  I don't know about stainless, either, 
but the factory studs were hardened, and the NAPA studs are not.  It 
seems to me the softer ones might be easier to drill out if snapped, but 
Mother Mopar always had a reason for things.

Sean


spigot2039@xxxxxxxxxxx wrote:
> 
> Hi all,
> 
> Will someone remind me the size / length I need for hanging a stock cast 
> iron manifold on a 383 head?
> 
> And is stainless advisable?


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.