Re: making heat shields
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: making heat shields



Home depot?  I will try it.  What are you fastening the heat sheilds with?


------Original Message------
From: Rich Kinsley
To: 1962to1965mopars@xxxxxxxxxx
ReplyTo: 1962to1965mopars@xxxxxxxxxx
Sent: Feb 18, 2009 2:57 PM
Subject: RE: making heat shields



I just finished making one for my fuel pump. It's really easy to do with 
some .019" sheetmetal I got at Home Depot. I almost think you could cut 
it out with some macho scissors but I used my left hand cutting tin 
snips. You can cut out what you think you need on the big side and then 
skinny it down for a final fit. I gotta think the more that is protected 
from the heat the better.
Rich Kinsley '64 Dodge POlara 4dr 318poly w/goodies
=====================================================================
neal zimmerman wrote:
> 
> Hi guys,I am thinking some heat shields in my 67 cuda engine
> compartment might not be a bad idea , what  with headers, maybe one
> around the brake switch down low on the frame rail, and one around the
> master cylinder.
>   What should i make them out of??  will aluminum help or is there
> something better like some kind of  heat shield laminate i can glue to
> the aluminum??
>    thank s
>   neal zimmerman, eugene oregon



Rich Kinsley '64 Dodge Polara 4dr 318poly w/goodies


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html. 



Sent via BlackBerry by AT&T


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html. 

This email was sent to: arc.6265@xxxxxxxxxxxxxx

u/?bUrDWg.bSONJP.YXJjLjYy



?p=TEXFOOTER




Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.