Re: Wiring harness wrap

[Mike Phelps <mikeph@xxxxxxxxxxxxx>]

${top_text_ad}
Thanks for the suggestions everyone. I'll probably go with the friction tape, at least for what can be seen.
Mike



----- Original Message ----
> From: Mike Phelps <mikeph@xxxxxxxxxxxxx>
> To: 1962to1965mopars@xxxxxxxxxx
> Sent: Saturday, February 28, 2009 7:18:55 PM
> Subject: Wiring harness wrap
> 
> 
> Any suggestions on what to use to wrap my wiring harness with? It 
> doesn't have to be OEM but I'd like it to look correct. Also is the 
> whole harness wrapped, even what is not seen? I guess it should be to 
> protect the wiring, huh?
> 
> Mike Phelps
> 1965 Plymouth Belvedere II Convertible
> 361/727
> 2004 Hemi Ram Quad Cab
> 2004 Chrysler 300M 3.5HO
> 2004 PT Cruiser 2.4 Turbo
> 
> 
> ----
> Please address private mail -- mail of interest to only one person -- directly 
> to that person.  I.e., send parts/car transactions and negotiations as well as 
> other personal messages only to the intended recipient, not to the Clubhouse 
> public address. This practice will protect your privacy, reduce the total volume 
> of mail and fine tune the content signal to Mopar topic.  Thanks!
> 
> '62 to '65 Mopar Clubhouse Discussion Guidelines:
> http://www.1962to1965mopar.ornocar.org/mletiq-----------


${bottom_text_ad}
----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.

This email was sent to: ${recipient}

u/?bUrDWg.${encoded_sub_id}.${EMC}