
Re: U-joints
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: U-joints
- From: Stevan Miner <miner@xxxxxxxxxxx>
- Date: Tue, 18 May 2010 06:12:08 -0500
Hi Merwin,
Spicer does make a u-joint for this type of application and as many as I've
installed, I should remember the part number but I don't. I'm at home right
now and don't have access to my shop stuff. If you can't find it at your
local parts store, let me know and I can get it to you.
Stevan Miner
Miner Auto Service
Winnebago, MN
--------------------------------------------------
From: "Merwin Wrisley" <vulcan@xxxxxxxxxxxxx>
Sent: Monday, May 17, 2010 1:42 PM
To: <1962to1965mopars@xxxxxxxxxx>
Subject: U-joints
I changed the rear end unit in my '65 Coronet, and discovered the yoke
was bigger than
the one on the unit I pulled out, it is about 1/2 inch wider. It appears
that I'm going to use a different sized u-joint, has anyone run into this?
I can't change driveshafts due to the ball & trunnion on the front end.
Any information will be greatly appreciated, Merwin
[Non-text portions of this message have been removed]
----
Please address private mail -- mail of interest to only one person --
directly to that person. I.e., send parts/car transactions and
negotiations as well as other personal messages only to the intended
recipient, not to the Clubhouse public address. This practice will protect
your privacy, reduce the total volume of mail and fine tune the content
signal to Mopar topic. Thanks!
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and
http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
----
Please address private mail -- mail of interest to only one person -- directly to that person. I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic. Thanks!
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
Back to the Home of the Forward Look Network