U-joints

[Merwin Wrisley <vulcan@xxxxxxxxxxxxx>]

    I changed the rear end unit in my '65 Coronet, and discovered the yoke was bigger than
the one on the unit I pulled out, it is about 1/2 inch wider. It appears that I'm going to use a different sized u-joint, has anyone run into this? I can't change driveshafts due to the ball & trunnion on the front end. Any information will be greatly appreciated,    Merwin
[Non-text portions of this message have been removed]


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.